Eiki LC-XT1 Manuál s instrukcemi stáhnout pdf (Strana 45)

LC-XT1

Follow these steps to replace the lamp assembly.

Check the number of lamp to be replaced on Lamp Status

Display.

Turn off the projector and disconnect the AC Power Cord. Allow

the projector to cool down for at least 45 minutes.

Remove the two screws on the Lamp Cover and press the

button to open the Lamp Cover. (See right figure.)

Loosen the two screws and pull out the Lamp Assembly to be

replaced by grasping the handle.

Replace the Lamp Assembly with a new one and tighten the two

screws. Make sure the Lamp is set properly

Replace the Lamp Cover and tighten the two screws.

Connect the AC Power Cord to the projector and turn the

projector on.

Reset the Lamp Replacement Monitor Timer. (Refer to the

section “Lamp Replacement Monitor Timer” on page 41.)

NOTE: Do not reset the LAMP REPLACEMENT MONITOR TIMER

when the lamp is not replaced.

CAUTION : Do not operate the projector while any of lamps is removed.

It may result in malfunctions, fire hazard, or other

accidents.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 51

Žádné komentáře

Eiki LC-XT1 Manuál s instrukcemi Strana 45